Introducing the MM-AE Series Inverter/charger - A new generation inverter in an all new design. The MM-AE is smaller, lighter and less expensive while retaining all the built in protection and reliability of ME and MS models. The MM-AE charger uses a PFC (Power Factor Corrected) charger, which is 85% efficient and the same charger topology used in all Magnum models.

The MM-AE Series is designed to accommodate smaller loads and appliances in cabins and off-grid homes.

The MS Series is ETL listed to the stringent requirements of UL/cUL 458 for mobile use and UL 1741 for off grid installations.

The MS-AE Series Inverter/Charger from Magnum Energy is a pure sinewave inverter designed specifically for the most demanding renewable energy applications. The unique design of the MS-AE Series can provide 120 and 240 volts AC output in one unit, eliminating the need to stack two units together to get 240 volts.

Available in 4000 (24 volts) and 4400 (48 volts) watt models, the MS-AE Series inverters are powerful, easy-to-use and ETL listed to the stringent requirements of UL 1741 and CSA C22.2 No. 107.1-01 for Renewable Energy installations.

The MS-PAE Series Inverter/Charger from Magnum Energy is a pure sinewave inverter designed specifically for the most demanding renewable energy applications. The unique design of the MS-AE Series provides two 120VAC output lines that are 180° out-of-phase with each other, so that the combination of the L1 and L2 lines total 240VAC and the voltage between either L1 or L2 and neutral is 120VAC, eliminating the need to purchase two units and stack them together to get 240 volts.

When the power requirements of the system are beyond the capacity of a single MS-PAE Series inverter or the system is expanded as more loads are added, up to four MS-PAE Series inverters can be connected together in a parallel configuration. When connecting inverters in parallel, the overall inverter power and surge capacity is increased to power a large single load or more smaller loads.

Available in 4000 (24 volts) and 4400 (48 volts) watt models, the MS-PAE Series inverters are powerful, easy-to-use and ETL listed to the stringent requirements of UL 1741 and CSA C22.2 No. 107.1-01 for Renewable Energy installations.

Introducing the RD Series Inverter/Charger - a new generation inverter designed specifically for Renewable Energy use. The RD Series is powerful, easy-to-use, and best of all, cost effective. Install the RD Series in four easy steps: Simply connect the inverter's output to your distribution circuits or electrical panel, connect your power cable (AC) to the inverter's easy-to-reach terminal block, connect the batteries, and switch on the power.