Introducing the ME Series Inverter/Charger from Magnum Energy -- A new generation inverter designed specifically for rugged recreational vehicle use. The ME Series is powerful, easy-to-use, and best of all, cost effective. The ME series is ETL Listed to the stringent requirements of UL/cUL 458, ensuring that the inverter is safe and reliable.

Install the ME series in four easy steps: simply connect the inverter's output to your distribution circuits or electrical panel, connect your shore power cable (AC) to the inverter's easy-to-reach terminal block, connect the batteries, and switch on the power.

Introducing the MM Series Inverter - A new generation inverter designed to accommodate entertainment systems and small appliances in smaller RV's, boats and trucks in an all new design. Based on the popular ME and MS series inverter/chargers the MM is smaller, lighter and less expensive while retaining all the built in protection and reliability of ME and MS models.

The MM models with chargers use a PFC (Power Factor Corrected) charger, which is 85% efficient and the same charger topology used in all Magnum models. The MM Series is ETL Listed to UL/cUL 458.

The MMS Series from Magnum Energy - a pure sine wave inverter providing a cost effective solution for those with smaller power needs in mobile applications. Versatile, easy-to-use, and lightweight, the MMS Series provides a reliable base for your energy system.

The MMS Series inverter is designed to accommodate entertainment systems and small appliances in smaller RV's and boats in an all new design. Based on the popular ME and MS Series inverters, the MMS is smaller, lighter and less expensive while retaining all the built in protection and reliability of ME and MS models. The MMS charger uses a PFC (Power Factor Corrected) charger, which is 85% efficient and the same charger topology used in all Magnum models.

The MMS Series is ETL Listed to the stringent requirements of UL/cUL 458, CSA C22.2 #107.1-01 and meets the KKK-A-822E standard.

The MS Series Inverter/Charger is a pure sine wave inverter designed specifically for the most demanding mobile and off grid applications. The MS Series is powerful, easy-to-use, and best of all, cost effective. Install the MS Series in four easy steps: simply connect the inverter's output to your distribution circuits or electrical panel, connect your shore power cable (AC) to the inverter's easy-to-reach terminal block, connect the batteries, and switch on the power.

The MS Series is ETL listed to the stringent requirements of UL/cUL 458 for mobile use and UL 1741 for off grid installations.

Introducing the new Mobile models of the HYBRID inverter/chargers. Based on the popular MS Series pure sine wave inverter/charger, the new MSH-M models add a "Load Support" feature. Load Support allows incoming AC to synchronize with the inverter's output and uses additional power from the batteries to power loads. A 4000 watt generator combined with a 4000 watt inverter could run a single 8000 watt AC load.

Two mobile models with neutral ground switching are available: the MSH3012M, a 12-volt, 3000 watt inverter with 125A charger and 60A pass-through; and the MSH4024M, a 24-volt, 4000 watt inverter with 105A charger and 60A pass-through. These Mobile models are listed to UL458 and CSA C22.2 No. 107.1-01.